Directions

From Logan Airport

 

Follow signs in the airport to get to the exit. As you reach the exit, there will be a fork in the road. You want to take the left-hand fork. Follow this straight for about 1-2 miles to a tollbooth. Try to get into one of the right hand tollbooths. After you go through the toll, you will be going into a tunnel. The tunnel is only two lanes, and you want to be in the right hand lane.

Ideally, at the end of the tunnel, you will want to bear right slightly, followed by a left hand turn under Route 93, and another left hand turn onto Route 93 South on ramp. Once on Route 93 South, you will see an exit for Route 90. However, with the Big Dig Construction going on, it may be possible that this alternative is blocked off. If it is, there will be signs clearly pointing the way to Route 90 (Mass Pike) and you can just follow them.

Once on Route 90 West (Mass Pike), follow to Route 495 North. (You will have to pay a $.50 toll on the Pike, and another toll when you exit onto Route 495 North.) Follow 495 North to Route 2 West. Follow Route 2 West to the first Gardner exit. (Next exit after 140) The ramp comes off into a rotary. Take the first right hand exit off the rotary onto Pearson Boulevard.

Go back to the rotary. Take the first right hand turn onto Route 2 West. Merge onto Route 2 West, but take the first exit you come to (Route 68.) This exit ramp also comes off into a rotary. Take the third right hand exit onto Route 68 South. Follow 68 South approximately 10 minutes. As you come into the center of Hubbardston, you will see a big playground on the left side, followed by a white church on the right hand side. Take the right hand turn immediately after the church onto Williamsville Road. We are a mile down on the right hand side.